Wiring diagram discrepancy
Thread Starter
|
Senior Member
Joined: Mar 2010
Posts: 1,413
Likes: 5
From: White Bear, MN
Wiring diagram discrepancy
On page 1710 of the SRT Service Manual the following wires are incorrectly labeled.
O2 sensor ground at connector C3 pin 6 is Black (BK) until splice S119 not Dark Green (DG).
O2 sensor signal 1/1 pin 7 is Black with Brown stripe (BK/BR) not Black (BK).
O2 sensor signal 2/1 pin 23 is Black (BK) not Black with Brown stripe (BK/BR).
I verified the signals do go to the correct cylinder banks per ECU pin.
This might help with others trying to modify ther O2 sensor signals.
O2 sensor ground at connector C3 pin 6 is Black (BK) until splice S119 not Dark Green (DG).
O2 sensor signal 1/1 pin 7 is Black with Brown stripe (BK/BR) not Black (BK).
O2 sensor signal 2/1 pin 23 is Black (BK) not Black with Brown stripe (BK/BR).
I verified the signals do go to the correct cylinder banks per ECU pin.
This might help with others trying to modify ther O2 sensor signals.
Last edited by tunaglove; Mar 2, 2012 at 10:34 AM.
Senior Member
Joined: Dec 2010
Posts: 12,780
Likes: 184
From: Lineville, AL
Re: Wiring diagram discrepancy
Not only that, but I was trying to figure out why my trunk light stays on after the interior courtesy lights dim and go out.
According to the wiring diagram, they are one and the same, however, this sure is not true on my Roadster ......
According to the wiring diagram, they are one and the same, however, this sure is not true on my Roadster ......
Thread
Thread Starter
Forum
Replies
Last Post
4drturbo
Engine, Exhaust, Transmission and Differential
21
Nov 12, 2018 04:50 PM
Wisconsinfdcrossfire
Engine, Exhaust, Transmission and Differential
3
Sep 20, 2015 10:04 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)