Has anyone ever installed a pre-cooler temp sensor
Thread Starter
|
Senior Member
Joined: May 2012
Posts: 1,166
Likes: 6
Has anyone ever installed a pre-cooler temp sensor
see pic for potential location.
Possible Part#s/candidates appreciated.
If I can get it wired into my Arduino I could do some dT's, otherwise I'd have to stick with the water in/out BTU/hr (kW) calc.. But it would be nice to know.
Yawn....
Just reviewing the lysholm LYS 1600 AX chart ...
My calc
Stock 74/155 14.5psi at 6000rpm = 16m3/min @ 0C 100kPa (605cfm intake)
Prs ratio 2.1
Chart says - SC discharge temp should be should be around the 260F mark (125C) and 62% adiabatic eff.
Holy good night batman!
PS b4 anyone asks - the Arduino logger is built but isnt commissioned yet. Work's keeping me away from home.
b22b
Possible Part#s/candidates appreciated.
If I can get it wired into my Arduino I could do some dT's, otherwise I'd have to stick with the water in/out BTU/hr (kW) calc.. But it would be nice to know.
Yawn....
Just reviewing the lysholm LYS 1600 AX chart ...
My calc
Stock 74/155 14.5psi at 6000rpm = 16m3/min @ 0C 100kPa (605cfm intake)
Prs ratio 2.1
Chart says - SC discharge temp should be should be around the 260F mark (125C) and 62% adiabatic eff.
Holy good night batman!
PS b4 anyone asks - the Arduino logger is built but isnt commissioned yet. Work's keeping me away from home.
b22b
Last edited by Billy22Bob; Oct 17, 2013 at 02:19 PM.
Thread
Thread Starter
Forum
Replies
Last Post
grip grip
Parts/Accessories for sale - Archive
31
Sep 27, 2015 10:06 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)