No Janet Jackson here
No Janet Jackson here
The pain of those scratches from errant rocks finally pushed me over the edge; I purchased the DC "bra" available from Crossfireshop.com. I hate these things but the chips are worse. Installation was the typical of these products pain-in-the-buttc has to be to get them to fit tight. Quality of stitching appears good, ditto on the fit. The only negative is the ink on embossed logo was worn through where the bara was folded for shipping. I plan to take all the ink offc the big winged Chrysler logo is a bit much.
I'd post a pix, but every time I try to do so I get a message back saying by JPG is "empty." (Help!)
I'd post a pix, but every time I try to do so I get a message back saying by JPG is "empty." (Help!)
Screw that. I had 3M film applied to the front of the car, mirrors, head lights, fog lights, and behind each wheel the 2nd week I had the car.
It is applied and cut on the car. It can be waxed, washed, can't be seen in photos. However you can see a very small line up close. It can be removed with a heat gun later down the road. Since it is clear the paint won't be a different color if removed.
http://www.dfwsbr.com/crossfire/3m/
Save your paint. Those aftermarket leather / vinal bras that just slip over the front bumper ruin the clear coat!
It is applied and cut on the car. It can be waxed, washed, can't be seen in photos. However you can see a very small line up close. It can be removed with a heat gun later down the road. Since it is clear the paint won't be a different color if removed.
http://www.dfwsbr.com/crossfire/3m/
Save your paint. Those aftermarket leather / vinal bras that just slip over the front bumper ruin the clear coat!
Here is a link to my detailers site. It goes directly to the 3M link to give more info on the product. Hot stuff. The guy he uses applies to all the local Ferrari, Lambo, top end Mercedies, BM's, etc.
http://www.zainomobiledetail.com/3MClearBra/index.html
http://www.zainomobiledetail.com/3MClearBra/index.html
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)