Slow acceleration after new plugs and wires
Slow acceleration after new plugs and wires
Today, I installed new NGK spark plugs and Magnacor wires on my automatic Limited Roaster. I was able to change all 12 out fairly easy and to gap and torque specifications. After completing the installation, I gave the engine a quick rinse, let her dry and took her for a few test drives. No problems as all, I noticed improved performance. Well, roughly 3 hours later, I went for another drive, no problems until I stopped at the first stop sign. When I tired to accelerate, I went at a dead slow pace! After about 10 seconds I stared to accelerate at normals speeds, but every time I stop it will do the same thing. The check engine light illuminated so first thing tomorrow I will have that read. It takes 5 seconds to rev the engine to 2000 rpm at park.. WTF!! I dont know what went wrong.. any ideas? I dont think its limp mode because im able to run through all the gears.. it just takes forever! Thanks in advance.
Chris
Chris
Re: Slow acceleration after new plugs and wires
Ok so last night I decided to reset the check light and everything else by disconnecting the battery cable. This morning I reconnected the cable and she is running light a champ again! Not sure what went wrong.. but im glad shes healthy again
Re: Slow acceleration after new plugs and wires
next time you rinse the engine off start the car when finished let the heat of the engine dry it, drive it or just let it idle until dry,,, i think you got something wet that shouldn't get wet and as it soaked in and it caused a problem,, over night it dried completly,, jim
Guest
Posts: n/a
Thread
Thread Starter
Forum
Replies
Last Post
Wisconsinfdcrossfire
Engine, Exhaust, Transmission and Differential
3
09-20-2015 10:04 PM
bobbie
WTB - Items/Parts Wanted to Buy - Archive
5
09-12-2015 12:49 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)