Hatch rebadging dimensions
Hatch rebadging dimensions
I have been thinking of removing the CROSSFIRE letters from the hatch.
I would like to have the positions of each letter in case I decide to reapply them.
These are the sizes for a 2004 Coupe, Later models are located farther up from the hatch lip. The other sizes are within 1/16", rounded to the nearest 1/8".
InfernoRedXfire has informed me that the 1.00" dimension is 1 15/16" (1.94") on the SRT's. This is to allow for the SRT-6 badge.
The letters are vertical, but follow the profile of the hatch lip, which is 5/16-3/8" lower in the center.
The letters are .73" high.
I would like to have the positions of each letter in case I decide to reapply them.
These are the sizes for a 2004 Coupe, Later models are located farther up from the hatch lip. The other sizes are within 1/16", rounded to the nearest 1/8".
InfernoRedXfire has informed me that the 1.00" dimension is 1 15/16" (1.94") on the SRT's. This is to allow for the SRT-6 badge.
The letters are vertical, but follow the profile of the hatch lip, which is 5/16-3/8" lower in the center.
The letters are .73" high.
Last edited by onehundred80; 03-04-2010 at 05:01 AM.
Join Date: Jul 2007
Location: Dallas, the Republic of Texas
Age: 64
Posts: 7,951
Likes: 0
Received 7 Likes
on
7 Posts
Re: Hatch rebadging dimensions
Originally Posted by onehundred80
I'm cheap, not easy, but cheap none the less.
I see it as too much hassle to properly apply new adhesive and get every letter standing PERFECTLY straight upwards with no lean.
James
Re: Hatch rebadging dimensions
The 1" dimension is for the 2004 Crossfires and all the others have a 1.94" dimension. This allowed for the SRT label to go beneath it.
Last edited by onehundred80; 04-19-2019 at 05:58 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Franc Rauscher
Troubleshooting & Technical Questions & Modifications
14
05-09-2016 12:04 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)