What part of Tn are you in ? I am in Cookeville and dont see any XF in these parts. Greg

Hi, I know its been 2 years since this post, but I'm hoping you still have these SC pulley bolts! I'll buy one or 2! Let me know! https://www.crossfireforum.org/forum...tml#post796162

Hello, I had a couple questions regarding nitrous setup, you seem to be the most knowledgeable on the subject. I hope you don't mind.

1. Did you spray through the shifts?
2. Should I run the activation wire on the progressive controller through a WOT switch on the pedal or is there a wire I can tap into on the throttle body?

Any info would be greatly appreciated, thanks

Wow my statement wasn't posted to piss anyone off Anthony. I was just saying you and others like Les have a lot tied up in the experimentation of going beyond the limits in the Crossfires. I don't have the time nor money to go where you guy's run so was just stating a fact not putting anyone down. I could only wish to have the expertise to do the work you can and go as fast as you do. My best time up here in the high altitude is 12.7 and that was with a 150hp shot of NOS.

Hello, hope you are good.

Do you happen to know does the 61mm eurocharged pulley for the srt6 use the same OEM bearing? Appreciate your time... Thanks

Hey how much did it cost you to have the Zex kit installed? Thank you, William

Anthony what else do you need to install these?

Sorry, I'm seeing this now. Send me your email address and I'll send you the full report. The autocheck is very bad.

Hey thanks alot for the help I really appreciate it. This is the ebay page with it. It has the vin at the bottom.

Chrysler : Crossfire Base Coupe 2-Door in Chrysler | eBay Motors