Up for sale are the next parts:
1. Hood latch set $80 shipped.
2. CROSSFIRE lettering $120 shipped or each letter $14 shipped.
3. Auto DIM rearview mirror $150 shipped.
4. Home Link Garage Opener $25 shipped.
5. Rear bumper side marker set $45 shipped.
6. Overhead dome light $45 shipped.
More pictures upon request.

 

More parts for local pick up:
1.Hood with emblem $320
2. Fender passenger( has dents near the door) comes with grille trim $150
3. Fender, driver side (it is bent but you can fix it by fingers) $ 200
Location: Fleming Island, FL 32003










Exterior side view mirrors assembly: $40 each plus $5 shipping for each.


.

 

More stuff
1. Door panels $100 each, local pick-up. The driver's side speaker cover is damaged.
2. Headliner $220 local pick-up
3. Windshield moldings, right and left only. Need restoration. All clips are here. You just need to stick them with double side adhesive tape. $70 for both shipped.

 

Hi I need the wire harness that plug's into the radio amplifier . Yes, the original amp. Need plugs plus 6 inches of wire. Can be reached at lividdevil@gmail.com

 

I'll check it out

 

Chrysler Crossfire Infinity Radio Amplifier $100 shipped.





A-Pillars $45 shipped.









Jack $45 shipped.

 

Door speakers set of 4 $90 shipped.

 

WTB lower dash (bolster) for 2004 gray

 

If you don't mind, please, send a picture of the part you are looking for.

 

Do you have the plastic piece from the underside of the Crossfire that covers access to the fog light? Drivers side, left.
Thanks,
Bob

 

I'll check it

 

It is still in the car. I'll remove it shortly and check the condition.

 

If it is the drivers side, wasn't there a non-airbag bolster on 2004's? If I remember it correctly, the 2005 and later has an airbag on the drivers side bolster. Just an FYI (if it is the case).


.

 

Installed a bigger TB so this one with 28K miles is for sale now. $75 shipped.

 

Correct. Just a covered foam pad across the front end of the panel.

 

Vacuum pump $150 shipped

 

Most that need to buy that pump also need some harness with it due to corrosion issues.
Do you have that ?

 

Do you mean the connectors with about 5" of wires?
Yes, I have it but I didn't find any marks of corrosion.

 

I believe George meant the car to which needs the replacement may have corrosion due to a flooded module/wiring so they would need the harness and wire pigtail to 'splice' the good connector into theirs.


.

 

Thank you George, that's what George meant.