Hello,

I've noticed the DIY intakes have become extremely popular recently. I'm in full support of these efforts and am here to offer up some better priced materials for what you may need. We have many, if not all, the materials you will need to fab something up at home, and often at much lower prices then what you can get.

We Carry:

3" mandrel bent and straight polised aluminum pipe
90 degree 3" Elbows and 3.5" - 3" elbows
3" couplers
3" and 3.5" band clamps
Intake Tubes
Air Filters

Also if you need something for another project don't hesitate to PM or email me. Good luck everybody.

Thank you,

Anthony

 

Thanks for the offer.
Do you have prices, or does it depend on quantity ordered?
I am seriously looking at a CAI like yours, but I think I would prefer the air filter behind the grill, so I would want the majority of your CAI parts, but with a couple of more 90 bends.
Is the 90 to the throttle body 3" or 3.5"?
Thanks.

 

I need Inconel 718 16 gauge 2.5" diameter tubing and U-J bends.

 

Spensley the 90 into the TB is 3.5" and reduces to 3" for the addition of the piping. If you are looking to go in to the grille area I would suggest 45 bends and twist them towards the front. We initially had a 45 in place of the 90 and it did just that, put the tube more towards the front then the side and resulted in an odd bend for where our filter is placed.

If you are interested in the 45's we have them for $20.00 each, 90's are $28.00 and are the long leg version (5X7"). Straight pipes go for $17.00.

The elbows are for sale on our website.

As for the Inconel, we do not carry that, mostly just Intake material at this time.

 

Burns Stainless... http://www.burnsstainless.com/

You're welcome...

 

Thanks, but Burns only sells Inconel 625. Pointless for me. Anyways, Burns is a bit of a rip off for 304 stainless. Ebay sellers are cheaper. Bet you'll never help me again