when I try to raise my top ,control button beeps nothing happens,trunk deviders are in the right position Cliff

 

Those darn tops can be finicky. Try cycling the wing a few times, open and close the truck lid, and double-jiggle the partition again while closely studying the little switch arrangement.

I doubt if anything is amiss. A lot of engineering went into the top's workings, and all of the limit switching and stops need to be just so. But so frustrating. As a last resort, the top can be operated manually. You'll need a particular tool to manipulate the locking mechanisms and the instructions set forth in the manual. If you don't have the manual, go to the PDF Documentation Collection stored in the SRT6 Forum.

Fiddle with it and check back in on any progress or failure.

 

Make sure that the trunk partition is properly seated. They are very finicky, you may think its is seated properly when it really is not. If that does not work you can raise the top manually using the "Multi Tool" and then have your dealer take a look at it.