My 06 refused to start several times the last couple of months. It would turn over but wouldnt start. The starter would stay engaged until the key was turned all the way to off. Also the spoiler started acting crazy, going up for no reason. The dealer said it was the crank sensor and replaced it ( $300.0 parts only) Now he tells me that it still will not run and say it's the ECM (2300.00 parts only) Shouldn't a bad ECM show up when he first scanned it? Is there a way to test the crank sensor after it is removed? Any help will be greatly appreciated













an

 

Don't spend your money yet. Do a search for these types of issues you're having. You will more than likely find the problem listed somewhere in this forum. These guys are a lot of correct help.

 

ecm has a 8year 80,000 mile warranty

 

Would you beleive I have 88000 on the car. Contacted Chrysler and they will let me know tomorrow if they can help me with the high cost of the part. Thanks for your replys guys. This forum is a great help to Crossfire owners.

 

Okay enlighten me.. ECM Electronics Control Module.. which one is this supposed to be..? BCM TCM ECU .. All under $200 on ebay.. and doesn't one of our venders have the ability to reprogram the vin specific requirements? "Rudy"?

 

Chrysler stepped up to the plate and paid 75% of the total bill for the ECM replacement on my Crossfire. I was turned down three times but persistence pay off. Still I thought it was very good of them to help. Been a mopar fan since my wife (then girlfriend) had two GTXs a Cuda340 and a Chrysler 300.
She even had an AMX. Her daddy had a car lot. Thanks again fellas

 

Glad to hear the stealership took care of you on this one but still interested in the answer to MrMiata's question anyways.