Hi guys i have a 04 N/A and im ready to install my needswings dual intake. I started looking around the engine before doing anything and i have the following doubt. How can i remove the plastic part which is connected to the throttle body? This part becomes visible after removing the engine cover. I dont see any screws (except for the ones on the sensor attached to it) and there are two clips at the upper part holding on to the engine so i believe there may be some clips hiding somewhere. By the way if there is any other pointer you might give me for the intake installation it would be appreciated.

Thanks

 

Installation instructions with pics typically come with purchase. If you didn't get them, Pm Rob and he'll e-mail them to you.

 

Thats great!! I'll try that
Thanks

 

I recently purchased a DCAI for my N/A from another member and need these instructions, can someone post the PDF please?