Hi has anyone got a Part Number (ideally for a Gates Belt and Pulley) for a SRT?

I ordered from Germany and went to fit it today and it miles to short and not wide enough and the pulley was also not wide enough.

I ordered the parts from Chrysler Crossfire Roadster SRT-6 V-Ribbed Belt / Set and the parts shown are the ones I received (Gates) but they are clearly wrong.

 

Got my last one from my local motor factor, SLK350 belt, can't remember how much it was though.

 

Anyone?

 

Gates #K081145

 

Thank You

 

I got that using a search, I hope it is correct.
The 1145 means 114.5 long inside measurement.
http://www.gates.com/

 

It seems correct but there is no listing for the part in Europe

This is a USA link Gates K081145 Serpentine Belt | eBay

 

Hi can someone tell me how much you pay for a SRT6 serpentine Belt and Idler pulley in the States?

I can't find a supplier in Europe (as stupid as that sounds) the German supplier who sent me the wrong part can not locate the correct items and so will refund me. But I still want to change the belt and pulley.

 

Gates Factory Belt

 

https://www.crossfireforum.org/forum...tml#post697973

 

Thanks for the heads up, Unfortunately I missed it by a day (Typical)

 

In case anyone comes to this thread looking for a new S-belt, the Gates K081145 is on Amazon for ~$34, with free 5 day shipping. There were 3, I bought 1.

 

Hi

have you looked at these

ContiTech Chrysler | Euro Car Parts UK

 

Looks like a NA belt by the year stated.

 

I agree NA - think it stems from the Gates own site where it shows the same belt for the EGX and EGZ engine.

This might help a bit - seems that some MB parts are less in price to Chryslers

CHRYSLER 5143206AA
MERCEDES 1129970092
ACDelco 8K1145
GOODYEAR 4081145
NAPA 25081145
GATES K081145
Outside Circumference :2924.18 mm,115.125 in
Top Width :28.45 mm,1.12 in
Ribs :8 mm,8 in

 

Think I have also cracked the Continental Contitec number 8PK2902

Think I am glad I have a NA Crossfire

 

If you look at it carefully then the inside circumference is the important one and manufacturers labels tell us what we want to know in many cases.
The Gates number K081145 says it has 8 ribs and the inside circumference is 114.5 approximately.

If you are desperate then you could measure the belt length with a piece of string and get a good idea of the belt length required and count the ribs. Take into account the tensioner requirement as well.
This has been mentioned on the forum before by Woody W if I remember correctly.