My Post Pictures

December 16, 2018

95

0

Scrubbed the metal cable contact point, looked with light & mirror, clean & shiny.

Scrubbed the metal cable contact point, looked with light & mirror, clean & shiny.

0 2024/01/12 15:45:08 GraphiteGh

Ran cable along slot between batt and electronics box.

Ran cable along slot between batt and electronics box.

0 2024/01/12 15:45:10 GraphiteGh

Trimmed the grey cover allowing cable terminal to protrude without losing the cap.

Trimmed the grey cover allowing cable terminal to protrude without losing the cap.

0 2024/01/12 15:45:13 GraphiteGh

Used a wire tye to secure cable to POS cable

Used a wire tye to secure cable to POS cable

0 2024/01/12 15:45:15 GraphiteGh

Another wire tye where cable slid along channel, holding it up inside channel.

Another wire tye where cable slid along channel, holding it up inside channel.

0 2024/01/12 15:45:17 GraphiteGh

Extra cable loop allowing engine/transmission to 'flex' some without stretching cable

Extra cable loop allowing engine/transmission to 'flex' some without stretching cable

0 2024/01/12 15:45:20 GraphiteGh

0 2024/03/18 13:02:24 GraphiteGh

0 2024/04/27 20:25:16 GraphiteGh

0 2024/04/27 20:25:31 GraphiteGh

0 2024/04/27 20:25:42 GraphiteGh

0 2024/05/24 16:18:40 GraphiteGh

0 2024/06/26 13:59:49 GraphiteGh

0 2025/06/03 17:20:09 GraphiteGh

0 2025/06/27 19:25:54 GraphiteGh

Left 3, came out of 5 wire RCM connector. Right 3 were replacements. Cut bad end off the wire, strip back, then solder new connector on wire. Make sure they are inserted back in connector correctly. DONE

Left 3, came out of 5 wire RCM connector. Right 3 were replacements. Cut bad end off the wire, strip back, then solder new connector on wire. Make sure they are inserted back in connector correctly. DONE

0 2025/06/27 19:27:07 GraphiteGh

Page
3 of 3

Go To
Page

Go to page of 3 pages

1
2
3