I see 5 in stock.

http://www.ebay.com/itm/221300205795?item=221300205795&viewitem&sspagename=ADME%3AX%3AAAQ%3AMOTORS%3A1123&vxp=mtr

 

Be aware that those are the fiberglass knock-offs that always don't fit so well without some finagling ....

 

FP....I think FUBU is looking to have ViS make some in a group buy.... Not sure how the fiberglass fit...but, you can manipulate fiberglass pretty well. Either way, I think they will be more available soon. But the factory 1's are long gone...

 

Thanks, I joined FUBU's list for the diffusers. I'm not interested in the one's on eBay. I just listed them should anyone be interested. Some folks know how to work fiberglass.

 

Initial fit up on these for the wife's car, the passenger side seemed to fit fine, the drivers side has too thick of an edge where it fits the "recess - contour" on the back of the bumper cover. They weren't uniform on that flange thickness and the lower 2" or so is going to need thinned down to fit flush into it. Weather - toy runs - etc. have limited my time to mess with them for the install. Thinking about it though.. We actually bought 2 sets of these and I haven't even opened the other box.. Drivers side might not have that extra thick flange... I'll have to check this weekend..

 

I just ordered a set for my car. I'll report back on fit and ease of installation in a month or two. Or three. Or six...

But I want it finished by CAA #5 this summer. So, that is my deadline!