Finally A Front Lip For The Crossfire.very Sharp Look.gives The Front End A Beefy Look! I Will Start Selling Them Asap.i Attached Some Photos Of The Lip On My Car. I Have Many Different Pics, So Just Ask And I Will Post More.

 

Nice looking piece of work.

 

here is a shot from the left side.

 

very nice, what's the cost gonna be, I'm very interested

 

there is a minor mod that has to be made to this lip. at each end about an inch needs to be cut off.the lip was a little too long. and like most lips priduced double sided tape needs to be applied to the rear of the lip to attach to the body. one screw on each side to hold the lip in place.price will be $149.99 for all who are interested let me know on this thread, or you can message me.

 

will get with you tomorrow on this ,im at work ,sounds good just need know what shipping will be to lexington kentucky thanks for the reply

 

That lip is so Phat!!!

 

I think it looks good too. Why is their extra that needs to be cut off? Do you have a close up of that area so I can see how it looks? Also, will the tap really be all that's required to hold it? How long will it hold up?

The pricing sounds good but I'm hesitant until I know a little more about the interface around the cutting area.

Thanks

 

this is hoe it looks on the side. my previous car had a single screw and the (red)automotive double sided tape.it held up for years.

 

 

the lip is made of poly urethane. since most do not know what poly urethane is; it is a very bendable material that is hard to crack or break, and is much better than cheap abs plastic.it is professionally made, and the screw at the end is due to the inch that needs to be cut off. the screw is so small and is the color black that it is barely visable.

 

May I suggest that you put a slight "return" on that portion of the lip end so that it closes the lip off at the inner fender and finishes off it nicely where it ends at the wheel well. That is also where the screw/fastener could be used if it is absolutely essential.

 

~ looks a bit too universal for me ... but ... it's nice to have an option for those who don't swap to the more expensive srt front bumper.

lip.jpg

 

Show this to Susan today and it a no, sorry man , she said like the Srt bumper better and save for that , I do like it but she been with me for 35 yrs , so if going to make 36 i;m going to pass on it Now if i see one on car in person it may change

 

no worries, i posted this up so we can all enjoy a lil mod.good luck on that srt bumper

 

I like it but I already have the SRT nose.

 

very interested but seems like the small screw will how on my SSB.....
really like the lip though but if the SRT nose is really calling for me....

 

Im defenatly interested! Looks Great!

 

Anybody work at a car lot? Measure the fender edge to fender edge around the front of a Honda?

EK EK9 JDM PU BUMPER SPOILER LIP BODY KIT+GRILL GRILLE | eBay

 

I am intrested however first i have a few questions.

What is the blue thing where the gap is that meets the lip and bumper?

Also i would like if you could take 2 more pictures;
1st - side view of car from say 15 feet back.
2nd - snap picture from the front looking down so i can see how tight the lip mounts to the front of the bumper meaes the 2 bottom grills.