I was at the Texas Motor Speedway this week for the Laps for Charity event. What a great event. Check out my pics in the Gallery.
While there I saw several cars with LED lights under the headlamps and would like to make that mod myself.

Is there anyone who can tell me where to go to get them and give installation instructions?

I apologize if there is already a thread to this but I have searched for a while and could not find one.

Thanks,

Jeff
OL_Coach

 

If you are talking about the Audi-esque LED under the headlights then yes it has been brougght up several times. I don't know if there are any install instructions, but I remember seeing a crossfire having them donoe and in all honesty I didn't think it looked up to par by any means.

Keep searching you will find it eventually.

 

Are you referring to LED's like these?

 

YES! That is what I am referring too! Where can I find those lights and do they require any special wiring?

 

Ok, I'll admit. That looks a lot better than some of the other ones I have seen.

Now if there is a write up on installation I will be even more impressed. Well done Cassidyjr1

 

Hi Jeff! I have those lights, we were right behind you in my Graphite Roadster and I had them turned on. It's pretty simple to do and I will post how tomorrow.
Take a look at my gallery to see photos of my headlights.
Paige

 

Wow. Nice job there.
Looking forward to the How-To!

 

Install many ways. If you can get thru firewall, put in cigar lighter (power outlet).Right now I have mine with alligator clips to pos/neg battery terms. Only temporary.

 

I had the Black SRT roadster there Saturday with them on. Heres the site I bought them at. Real cheap and easy to install! Just push them in between the gap between your headlight and your bumper. The strip is encased in a rubber tube and very flexible. I spot siliconed mine in just in case! I spliced them into my side marker lamp wiring and come on when I turn them on. Another good place to tie them into is your fog lamp wiring if you want them just when you have those on. The wiring is easier to get to also.just go through the little panel in your inside fender well and just use those splice clips they make so you dont have to cut your wires ..Mikenewb

Pack of 2 30cm 15 LED Car Headlight Strips Light for Audi R8 S6: Virtual Village - US

 

Thanks for the link Mike.
Ordered two sets.

Paige. Where's that How-To?

 

https://www.crossfireforum.org/forum/exterior-lighting/32286-i-used-turn-my-hids-during-daytime-running-lights.html?referrerid=23745


I couldnt figure out how to reference the thread above so I just copied and pasted the link. I was going to take a pic earlier of my setup but it was too dark this morning. This link has the instructions I followed when I first put my lights in. This is the website where I ordered them:
LEDs - Ribbon Thin, Flexible, Waterproof & Bright LED Strips

Like they said above, they are pretty easy to install. Just trim to the length you want. Push them between the headlamp assembly and bumper bringing the wires under and through the inside corner of the headlight. From there, we just soldered them to the parking light wires. We didnt have to remove the headlight or anything. The only problem I have had since then is my "bulb indicator light" is on. I know there is a way to fix this but I havent had time to research it.
Hope this helps!
Paige

 

Oh they posted the fix! Real easy one too! Mine came on when I did my HID bulb installs. They dont draw as much current as the normal bulbs so the car thinks theres a problem. Theres not, its just pulling less voltage. The fix is simple! put a small piece of electrical tape over the indicator light! Taa Daaaa! No more light! Ive forgotten about mine and didnt remember til you asked! :-) Mike

 

Okay, I attached a few photos that might help. There are other ways of doing it but this is what mine looks like. =)

 

My name is Claire Bartels and I'm the Assistant Marketing Manager at VirtualVillage.com. To say thanks for the mention I wanted to give you guys a coupon code to get 20% off the product total of your next order with us. Simply input the code during checkout to apply the discount. The code is VVN392R.

Please don't hesitate to contact me directly if there is anything more I can do to help you.

Claire Bartels
Assistant Marketing Manager
Main Page: Virtual Village - US
Monster selection. Tiny prices. Direct from Shanghai.

 

My email address btw -
claire.bartels@virtualvillage.com

Regards,
Claire

 

Oh sure.
NOW there's a discount AFTER I order TWO sets!

 

Paige!
Thanks for your reply to my post. I look forward to making this mod to my Crossfire. I had a great time at the event in Dallas as did my wife and daughters!

Jeff

 

Thanks Mike also ordered a set

TERRYR

 

Just ordered them. God, I love our Forum!

 

i want this, but dont have time to do it, so anyone who is near nebraska that wants to do it for me for some cash, let me know, haha