Found source for top tool < $25
Thread Starter
|
Senior Member
Joined: Dec 2010
Posts: 12,780
Likes: 184
From: Lineville, AL
Found source for top tool < $25
This is the combo tool ( includes hex bit for the bow latch )
https://www.ebay.com/itm/Mercedes-W2....c100284.m3505
https://www.ebay.com/itm/Mercedes-W2....c100284.m3505
Senior Member
Joined: Apr 2006
Posts: 25,432
Likes: 648
From: Ontario
Re: Found source for top tool < $25
1 1/2” seems a bit much.
Joined: Aug 2016
Posts: 62
Likes: 0
From: Spain
Re: Found source for top tool < $25
I need to either buy or fabricate one of these, and for <$25 I cant see the point in fabricating one.
So, does it really need 1.5" cutting of the hex head?
(and thanks for sharing ala_xfire)
So, does it really need 1.5" cutting of the hex head?
(and thanks for sharing ala_xfire)
Joined: Jan 2017
Posts: 146
Likes: 0
From: Carmel, Indiana
Re: Found source for top tool < $25
Your best bet is to get the tool and try it out first. The one I received was too long to maneuver into position. I simply cut half off and now is a whole lot easier to use.
Senior Member
Joined: Apr 2006
Posts: 25,432
Likes: 648
From: Ontario
Re: Found source for top tool < $25
Buy a tool that you need both ends and then saw it in half or just cut 1 1/2”, only one can be correct.
Joined: Aug 2016
Posts: 62
Likes: 0
From: Spain
Re: Found source for top tool < $25
Senior Member
Joined: Apr 2006
Posts: 25,432
Likes: 648
From: Ontario
Re: Found source for top tool < $25
That makes sense.
Administrator
Joined: Jun 2009
Posts: 13,968
Likes: 1,294
From: Fort Worth, Texas
Re: Found source for top tool < $25
The hex bit on there DOES look awfully long. I use the factory tool and carry a hex key and I remember that the key just about fits and the 'elbow end' is maybe an inch long.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)