Does anybody out there know if it is possible to remove roll guard from crossfire convertible. I need to remove passenger side so my homecoming queen granddaughter can ride back there in homecoming parade.

 

I believe they bolt to the rear bulkhead through the trunk area. There may be some good info here.
https://www.crossfireforum.org/forum...#&gid=1&pid=13

 

Use cation
I’ve taken that area apart a few times.

I wouldn’t recommend removing it and more importantly, once you look inside the area you’ll come to the immediate conclusion that having some one sit on that area is a sure fire way to ensure your top never works again.

 

.


Before removing a safety roll bar, maybe you should either let her stand up OR place a few towels/mats on seat to stand on. Sometimes, removing safety equipment results in not putting them back after a special event. There must be not enough room to sit in between then (at slow speed) or you would let her sit centered there (on a few blankets/pillows)? You wouldn't want it (roll bar) missing when needed, would you? Good luck (maybe a different vehicle?)!


.