Noise!?!?!
I am getting a noise from the front of the car, engine or trans?, it is a squeak around 1.5-2k going into 2nd gear.
Mods are NW intake and Code 3 Pulley.
Thanks for any input.
Mods are NW intake and Code 3 Pulley.
Thanks for any input.
Originally Posted by slow4dr
I am getting a noise from the front of the car, engine or trans?, it is a squeak around 1.5-2k going into 2nd gear.
Mods are NW intake and Code 3 Pulley.
Thanks for any input.
Mods are NW intake and Code 3 Pulley.
Thanks for any input.
Only while driving when the car shifts from 1st to 2nd, I will try and get a video up tomorrow. It only does it when the car is cold after driving for a few minutes it goes away.
Originally Posted by slow4dr
Only while driving when the car shifts from 1st to 2nd, I will try and get a video up tomorrow. It only does it when the car is cold after driving for a few minutes it goes away.
Mine does the same thing. It is a small "chirp". You are not alone.
https://www.crossfireforum.org/forum...when-cold.html
I don't know if anyone has found an official cause or repair, or if anyone
has actually experienced supercharger failure after hearing this.
Originally Posted by amx1397
sounds like bearning. on pully oir idler. jim
i just replaced mine.
Originally Posted by Ringmaster
Mine does the same thing. It is a small "chirp". You are not alone.
https://www.crossfireforum.org/forum...when-cold.html
I don't know if anyone has found an official cause or repair, or if anyone
has actually experienced supercharger failure after hearing this.
https://www.crossfireforum.org/forum...when-cold.html
I don't know if anyone has found an official cause or repair, or if anyone
has actually experienced supercharger failure after hearing this.
Another question for the knowledgeable:
I had my valve cover leak fixed at the local Dodge dealer, well since I own the only srt-6 in Caldwell County they don't work on them much, needless to say it is leaking again. Is there any tips that I can give them so they get it on right if I take it back, or I might just take it to a friend that is a mechanic. Does anyone know how much the seal cost and is that all I would need.
I had my valve cover leak fixed at the local Dodge dealer, well since I own the only srt-6 in Caldwell County they don't work on them much, needless to say it is leaking again. Is there any tips that I can give them so they get it on right if I take it back, or I might just take it to a friend that is a mechanic. Does anyone know how much the seal cost and is that all I would need.
Thread
Thread Starter
Forum
Replies
Last Post
ty_ty37
Crossfire Coupe
29
Jun 27, 2024 10:42 AM
2005 Ragtop
Wheels, Brakes, Tires and Suspension
7
Oct 3, 2015 03:01 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



