I'm trying to configure the Dashdaq to read boost from the MAP from the OBD2. I've tried following Rob's instructions from a while back, but they aren't working for me. I would get the info from the Dashdaq forum, but the servers have been down since last week.

Thanks in advance for the help.

 

Here's the settings from the manufacturer that worked like a charm:

Try these settings in your calculator:



Input Signal: MAP

Multiplier Signal: Constant Multiplier from Rescale Calculator

Multiplier Sign: 1

Constant Multiplier: 1

Offset Signal: Constant Offset from Rescale calculator

Offset Sign: -1

Constant Offset: 14.7

Name: boost

 

For those wanting to connect their widebands to the Dashdaq without spending $50 on the wideband add-ons, you can connect the analog wire from your wideband to the Dashdaq cable and adjust your settings this way:


Offset: 7.35

Factor: 3.008

 

Thanks for the info! One question - where did you place dashdaq in your interior, it’s quite big and doesn’t look nice but still very needful thing to have!

 

I mounted it on the windshield with the supplied suction cup mount.

 

Have you got any photo of that?

 

its smaller than my garmin gps. i had a friend make me a custom bracket and mounted mine just to the laft of the mirror using the oem visor screw. ran all the wiring up the a pillar and across out of sight.

 

+1 on what Steve said. Here's a photo of my Dashdaq beside my Nav unit.

2012-02-13_17-43-07_98.jpg

 

heres my setup

 

Your Dashdaq is at least 10 times smaller than mine.

 

dont know how to make as big or as fast as yours!!

 

You've got the "fast" part covered, but mine will always be bigger.

 

OUCH!! i walked right into that one!