Has anyone installed a catch can on an SRT-6? The tee seems different than the one in needwings instructions must be NA? Also the tee for my throttle body is in bad shape. Does anyone have a part number and source for a new one? Any part numbers for the throttle body gasket? Might as well do it right.

Thanks

 

You can see the NA and SRT instructions in my thread below ( they are near the bottom under the Needswings heading) and you can compare them to what you have.

 

Thanks again sir you are always to the rescue. Any thought on replacement Tees? Over the years the rubber goes bad.

 

Sorry I cannot help. Put a plea out on the forum.

 

4 bucks cheap cheap ....
https://www.fcpeuro.com/products/mer...tor-1120180209
Not sure it fits the SRT6 though.

 

Doesn't look like it but thanks for trying.

 

.


Like George suggested, although this didn't fit your needs there are ALWAYS less expensive alternatives! Good luck in your searches!


.

 

I installed this catch can earlier this year.
located in front of oil dip stick. I made a bracket which mounts on to the water pump flange.
I combined both breather hoses into one hose then to inlet on the can.
The return hose connects to the venturi port on the throttle body. I blank off the other side of the return port.
https://photos.app.goo.gl/QweX1Na8eJeGGZUDA

 

You can send needswings an email and see if he has a spare for sell. He's bailed me out on obscure srt-6 only plastic/rubber bits before.