Hey guys, I hope someone has an idea how to help with this issue I’m having. I’m working on my SRT6, it has a fried power seat motor that moves it forward and reverse. The control that tilts seat back works, just not the forward/reverse for the seat bottom. I’m going to replace the motor section, but can’t get to
the rear bolts. I can’t even see them the seat is
back so far. I have the front bolts out. Does anybody have any idea how I can move this thing? Thanks for any help.

 

Hello,
I did a little digging in the service manual( you can download it off this forum) for the 2005 SRT. PG 1303,1312,1324, and 1326 in the manual has a trouble shooting sequence . On page 1312 it has a jumper sequence talking about your exact problem.
Hope I helped

 

Thanks for your help. I knew my motor was fried because it got wet so I had to find another way to move seat forward to reach those back bolts. I ended up removing seat cushion to access motor, removing motor and then using a drill in the exposed shaft to move seat forward.

 

Awesome thanks for the follow up to let others know how to do this task in the future.

 

I think you are too smart for this forum, 😉we have had this question before and nobody had an answer, you showed us all up, well done.

STICKY, someone?

 

Thanks, I have a YouTube channel called “Rebuild It” and we are working on this SRT. I will post the link showing what we did when the episode goes live.

 

Here is the link to the YouTube series where we address this issue. The seat removal is in episode 2.

You Tube