Chrysler 3.5 V6 motor
Re: Chrysler 3.5 V6 motor
the right arm is off the van and I have started cutting it and removing the drum hub. its greasy and wax coated, so I may take it to school tomorrow and put it in the autowash. this project is showing me what i'm made of--and it feels like mush right now. I am addicted to results, and there are too many open items working -- I just put the van on stands for the suspension fit and the fuel tank work, along with the wire routing.
Last edited by thummmper; 03-13-2011 at 02:54 PM.
Re: Chrysler 3.5 V6 motor
the autowash is just great--6 pressure heads and a rotating cage. only a bit of wax inside remains. Ive been detained with studying for my mid term in auto electronix--- I can give it hell again after school tomorrow--
I was scared to death that I was dropping my hands with this project, but I'm just curious as to how she will drive--I just have to buy some more patience
I was scared to death that I was dropping my hands with this project, but I'm just curious as to how she will drive--I just have to buy some more patience
Re: Chrysler 3.5 V6 motor
halfway done with the rear brakes, gents
and it's installed, although it's hard to believe that this nasty hub
is now this
and the drive hubs are in place as well, so it will be a length of halfshaft game now...
the shocks will be replaced with bilstein monotube HDs
and it's installed, although it's hard to believe that this nasty hub
is now this
and the drive hubs are in place as well, so it will be a length of halfshaft game now...
the shocks will be replaced with bilstein monotube HDs
Last edited by thummmper; 03-24-2011 at 11:39 AM.