possible pulley sound.. any suggestions
possible pulley sound.. any suggestions
Hi guys,
I've got a low clicking sound coming from what I believe may be a pulley. Can you take a look at this video and see if you believe the same?
I'm ordering the correct socket so I can take off the belt and give the pulleys a turn to see if any is binding. At this time I think it may be the water pump (It looks as though it may have a slight wobble). Anyone else had an issue with this sound and/or the water pump? Any info is appreciated. Thanks!
I've got a low clicking sound coming from what I believe may be a pulley. Can you take a look at this video and see if you believe the same?
Re: possible pulley sound.. any suggestions
Last edited by onehundred80; 10-15-2015 at 10:36 AM.
Re: possible pulley sound.. any suggestions
I was under the impression that I needed to have a torx bit in order to loosen the tension pulley. I do not have any. That is why i mentioned that i had to order the tool to get to it. I appreciate the quick responses! You guys are easing my nerves. Thank you!
Re: possible pulley sound.. any suggestions
A Torx bit is used on the SRT tensioner. A 17 mm socket is used on the Base and Limited, you use the cast in hexagon, that is why it is there.
If you use the Torx bit make sure it is the correct size, too small and you can kiss the screw head goodbye, it has been done here before.
You get a much better grip with the socket.
If you use the Torx bit make sure it is the correct size, too small and you can kiss the screw head goodbye, it has been done here before.
You get a much better grip with the socket.
Thread
Thread Starter
Forum
Replies
Last Post
soxih
Troubleshooting & Technical Questions & Modifications
2
01-19-2016 06:02 AM
BlueFire
Troubleshooting & Technical Questions & Modifications
2
10-22-2015 05:27 PM
tritongreen
Troubleshooting & Technical Questions & Modifications
0
10-08-2015 02:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)