Hi I'm new here. Anyway.
I have a 04 crossfire base.
I tinted my tail lights red.

As you know,
the outer bulb is the brake light
the middle is the blinker
and the inside bulb is the reverse

I wanted to make the middle blinker and reverse into a brake light.
but also wanted to make all bulbs flash.
(maybe a sequential timer for kicks)
i tinted the reverse too so figured i might wire the reverse separately to an external reverse bar.
so I guess I want all lights to blink but also turn on when braking.

Anyone have a tail light wiring schematic?

BTW : Thanks for the radio diagram to whoever posted it with the corresponding sides and polarities. Helped tons and now my crossfire bumps with the stock amp

​​​​​

 

You can access the service manuals that contain the wiring diagrams in the below link.

 

I was able to pull it up at school using shop key pro.

So what I did was bridge the brake light + wire to the blinker + wire.
Its pin 3 to 4 on the harness connector.
Only thing now is my blinkers turn on when I brake as well the indicator on the cluster.
What I need to do is install a diode on the blinker wires so that current can't travel up to the pcm and indicator lights but only current going to the bulb.

 

Thanks for the link. will definitely help. I'm gonna do my instrument cluster ligjt s next

 

Wouldn't a diode , cause the light out indicator on the dash , to constantly light, not being able to complete it's cycle check , for not working bulbs?

 

Can you add dual filament sockets for the additional lights you need?