i have a great friend who builds the most awesome paddle shifter setups. so who better to contact to build me a dasdaq bracket to allow me to read my DD while traveling at high speeds! i tried over by the glovebox to far away. i tried down by the drivers vent and have to take my eyes off the road to see it. this setup is simple and perfect. if it interests you and enough folks want it he might be convinced to build a few more!
you can still use the visor and it mounts with the factory visor screw. i ran all the wiring up the a pillars and across. took me less than 1 hr for everything.

on to the pics! sorry i dont know how to make them bigger

 

The photos are real small and I don't know what I'm looking at, but I need one too.

Les

 

Try this method from Valky, it works a treat.
https://www.crossfireforum.org/forum...tml#post312313

 

i felt lucky just being able to get them from my email to my downloads to the thread!! ill try to do it again.

ok i have tried every way i know to make them bigger wothout success. if someone thinks they can ill forward the email with the pics and they can post them here

 

Steve,
I can post the full sized original pics tomorrow if you can't work it out

Btw, your trim piece shipped today

Chris

 

Looks great, Steve. If I had a Dashdaq, I'd be buying one right away.

 

Steve, do you have a Zietronix? If so, how did you route the harness so you can plug it in too?? Or do you only use the Zietronix harness and that is what you run up the pillar and across? I use the ODB II and the Zietronix connections on mine... the Zietronix harness is in the passenger foot well and I run the ODB II over the steering wheel... Of course I dont have mine hooked up all the time... only when I want to monitor at the track....

 

yep i have the zt-2 and d/d. combo. the obdII runs up the drivers a pillar and the zt-2 cable runs up the pass. pillar and across to the d/d. theres plenty of room across the front were all the wires for the mirror and homelink and interior lights run. i also have the extended harnesses that rudy built for the setup
i use my dashdaq virtually every time the car goes out. even if i dont datalogg im monitoring what the engine is doing.

chris please post the pics. i have tried tinypic sending them to ifoto and my downloads and they still come up small

 

Here ya go ... These are the original (full sized) pics
Chris

 

It is possible that I will make a bracket that will mount the DashDaq and the Ultra-gauge (one at a time : )

I still have the mock-ups of the DashDaq .... and I have an Ultra-gauge

Chris

 

Looks great guys!

 

Very nice, I'll keep my phone on this weekend in case you need someone to bail you out of jail.