GF Performance Chip
Has anyone tried this and if so, good or bad results? This is the $69 Car Prformance Chip from www.GFchips.com
Also, is it very easy to install, I am not mechanical at all
GF Performance Chip Kit for the CHRYSLER CROSSFIRE Thanks so much for the info
Also, is it very easy to install, I am not mechanical at all
GF Performance Chip Kit for the CHRYSLER CROSSFIRE Thanks so much for the info
Originally Posted by Don Wood
Has anyone tried this and if so, good or bad results? This is the $69 Car Prformance Chip from www.GFchips.com
Also, is it very easy to install, I am not mechanical at all
GF Performance Chip Kit for the CHRYSLER CROSSFIRE Thanks so much for the info
Also, is it very easy to install, I am not mechanical at all
GF Performance Chip Kit for the CHRYSLER CROSSFIRE Thanks so much for the info
Originally Posted by onehundred80
There is a search feature at the top of this page, enter 'chip' (or 'crisps' if you are in the UK) and see the results.
OK, here is the very, very short version answer......RIP OFF!.....
Everything I have read and heard says stay away from those cheap resistor type "chips" confuses MAF or IAT sensor into thinking either air is real cold or real hot not sure which.
See web site http://www.carperformancechipreviews.com/ and specifically the following
Shipping Speed: 1/5
Customer Service: 2/5
Return Policy: 1/5
Average HP and Torque Gain: 1/5 (For each vehicle tested we noticed a loss of 8-15 HP)
Average MPG Gain: 1/5 (We notice huge losses in MPG. These varied from 3-10 MPG.)
Cost of product: $69.00
8. G-Force Car Performance Chip - GforceChips, GFchips.com Reviews
Ordering Process: 1/5 Shipping Speed: 1/5
Customer Service: 2/5
Return Policy: 1/5
Average HP and Torque Gain: 1/5 (For each vehicle tested we noticed a loss of 8-15 HP)
Average MPG Gain: 1/5 (We notice huge losses in MPG. These varied from 3-10 MPG.)
Cost of product: $69.00
Thread
Thread Starter
Forum
Replies
Last Post
grip grip
Other Cars Etc
19
Sep 19, 2015 08:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



