Can anyone help me with what I beleive is a security system problem.
Here is what Happens:
Sometime when driving - it just shuts off and wont start again - at least not for a while.
It cranks over - but no spark?

Sometimes when I go to start my 2005 Crossfire SRT6 - it just cranks and wont fire up?

Has anyone had simlar issues? any recomendations on What I should try to do?
any advice will be appreciated
Thanks,
Greg

 

Sounds like the action caused when the CPS (Crank Position Sensor) needs to be replaced
Buy only a Bosch CPS and no others as Bosch is the only one that will work
You can purchase this one on Amazon


I have attached a link below to help show you how to replace your CPS

 

Do you have any codes when it is scanned?

 

I have not had it scanned yet, I do not have the ability to do that, as I do not have the tool.
Never the less, I just ordered a new CPS. Once installed, Hopefully this will allow me
to drive far enough to get it to my service guy.

Thanks for the recommendation,
Greg

 

Greg
Click on the attached link for the CPS installation.....
BTW, where are you located in Pennsylvania?
Regards,
Dennis
DTMenace

 

Yes,
Pennsylvania.
I did order that Bosch CPS. Should be Here later this week.
I will Install it - then take car to my Service Guy - to be scanned.

Greg

 

There are tons of readers that will work with these cars, not having one makes you dependent on another person - I'd not put up with that. I like my BOSCH 1100, the "CP123" products are more expensive but even better than what I have.

I"d go buy one today. Also, a bad crank sensor may or MAY NOT set off the CEL - the sensor can fail such that no code is set, mine set a code, but I've heard others say they got no code when the CPS failed.

 

When my CPS failed twice getting it home, no code.