Car dies after approx. 15 miles travled
Car starts always when cold . After approx 15 miles it fades and dies. It will crank at this time with difficultly, but will not start. Waiting 46-60 minutes, the car starts and runs normally for a few more miles, then same problem is repeated. Does any of this sound familiar to anyone, if so please contact me. Thank you
Car starts always when cold . After approx 15 miles it fades and dies. It will crank at this time with difficultly, but will not start. Waiting 46-60 minutes, the car starts and runs normally for a few more miles, then same problem is repeated. Does any of this sound familiar to anyone, if so please contact me. Thank you
.
Car starts always when cold . After approx 15 miles it fades and dies. It will crank at this time with difficultly, but will not start. Waiting 46-60 minutes, the car starts and runs normally for a few more miles, then same problem is repeated. Does any of this sound familiar to anyone, if so please contact me. Thank you
most likely this is caused by a failing crankshaft position sensor. It's not hard to replace and you should always carry a spare as well as a spare RCM and the tools to replace them.
Here's a link to a post I did on how to replace the crankshaft position sensor: LINK - CPS replacement
Bosch crankshaft sensor , good price here also available on Amazon https://www.walmart.com/ip/Bosch-026...QaAr9EEALw_wcB
Thanks all- very helpful.
noticed that I had a sensor replaced recently, but it was the cam position sensor listed on the receipt, not crank sensor. Hopefully this will be the ticket.
cheers
noticed that I had a sensor replaced recently, but it was the cam position sensor listed on the receipt, not crank sensor. Hopefully this will be the ticket.
cheers
Keep us updated. Good luck!
Simple diagnostic, keep a bottle of water in your car, go for a drive to replicate your issue. Pour the water on your cps, if the car starts replace the cps. Cheap and easy enough fix.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



