Rear winged emblem
Re: Rear winged emblem
Just replaced my front and rear emblems. Drill small holes 1/8" diameter vertically 5 or 6 in the center from top to bottom. Not to deep just barely through the clear top dome maybe 1/16" to 1/8" take your time be careful not to deep. Then I took some very small sharp diaginal wire cutters and cut between the holes until you can grab it and twist easy and pull the 2 halves out one at a time. Just dont drill to deep it was a very easy job to do. Hub caps too, replaced all 6 with new crossfire emblems. Looks great.
Re: Rear winged emblem
Sorry I also took the rear wing emblem off because the original double sided tape had partcialy come loose no bolts just double sided tape. Used the 3M automotive double sided tape on the wing emblem also on my truck badges 3 years ago after new paint job still tight as new. Use dental floss to cut the emblems off, then clean very well with alcohol to remove any residual tape or glue. Not that hard just get it clean.
Re: Rear winged emblem
I found the info here under search don't really remember where, description only no pictures.
No bolts or push on clips under rear wing emblem double sided tape removed only because loose.
Use dental floss to remove rear wing emblem from trunk/hatch lid.
Use drill method to remove badges from wing emblems don't need remove wing emblem form car.
Front wing emblem has push on clips to hood.
Front and rear badges no bolts or clips just silicone.
Hub cap badges silicone only removed with drill method.
No bolts or push on clips under rear wing emblem double sided tape removed only because loose.
Use dental floss to remove rear wing emblem from trunk/hatch lid.
Use drill method to remove badges from wing emblems don't need remove wing emblem form car.
Front wing emblem has push on clips to hood.
Front and rear badges no bolts or clips just silicone.
Hub cap badges silicone only removed with drill method.
Thread
Thread Starter
Forum
Replies
Last Post
2005 Ragtop
Wheels, Brakes, Tires and Suspension
7
10-03-2015 03:01 PM
Idrenak
Parts/Accessories for sale - Archive
6
09-19-2015 08:17 PM
steps
Troubleshooting & Technical Questions & Modifications
2
09-12-2015 09:23 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)