Grill mod after installing Needswings CAI
There is a little wiggle room with these. I installed larger Edelbrock filters and still have room. You can work the aluminum elbows in a bit farther and angle the filters down a bit, there should be enough room that you won't have to mess up your grill/
Thanks I will have to try that. I looked at it again last night and it seems that it is hi in the back and it is not as close to the passenger side heat sheild as it is in the pics. Back to the drawing board and a few more cuts and scrapes.
Well with a little wiggle and waggle, few choice words, a six pack, and some love I finally got it all to fit properly. Thanks for the help and advice.
Hmmmm possible to hydrolock motor with filters right there if driving in heavy rain? I just installed my DCAI this past weekend and it dawned on me. Probably more so if the grille is off.
I've been through some frog stranglers and some flurd toaters with mine, no issues.
I believe the forward facing and top portions do get wet, but the bottom and backside stay
dry enough to allow sufficient air supply.
I believe the forward facing and top portions do get wet, but the bottom and backside stay
dry enough to allow sufficient air supply.
You won't need the pre filters but if it gives you peace of mind, then it works. I have been running mine since the dual came out. Never had a problem. I have plenty of room with my new, made in England grilles....
I use the pre-filters more for extended service life(cleaning & re-oiling)than trying to keep water out. The black is also great at camouflaging the filters through the grill.
So it immediately got tested. This was a sudden storm on US 431 where I actually had to pull over as the wipers couldn't keep up.
I have the needswings supercooler and I'm having trouble getting it to fit, does anyone know how to troubleshoot this? The new heat exchanger takes up much more space so I can't get the grill on
Thread
Thread Starter
Forum
Replies
Last Post
LE Cross
Interior
31
Oct 17, 2016 06:35 AM
3spencer3
Troubleshooting & Technical Questions & Modifications
2
Jul 24, 2015 01:08 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)







