Wiring question - were does this attach?
I put them on the track of using the "Crossfire Documentation Collection", (thanks 180) an downloading the service manual for their roadster. CLP/SSM is the only conclusion I could get to. B said the anti tow sensor was hooked up. Different colors than my manual shows , but mines not a "ragtop".
I'd forget where that plugs in for now, and tear the trim out of the entire trunk and inspect the modules on both sides of the trunk (top module, locking module, etc.) and see if they look like they are water damaged. If they are, you have way more issues than one connector not plugged into where it belongs.
Thank you everyone! The inside panel has a light that connects. We ordered used trunk interior and found the connector for the plug. Unfortunately that didn’t solve our problem with the top not open or close using the button.
I see that we focused on the trunk light, I now see that your original question was split into two parts by the photos.
Your main problem is the top not working. That should have been the main part of your question, a lot of time has been wasted on the trunk light.
I’ll leave that problem to the experts.
Your main problem is the top not working. That should have been the main part of your question, a lot of time has been wasted on the trunk light.
I’ll leave that problem to the experts.
Until we figure it out, the top doesn’t work, doors don’t lock/unlock with fob, interior lights don’t come on when doors open, etc.
Last edited by onehundred80; May 13, 2018 at 10:42 AM.
Thanks for your reply, but I am grateful for the help with the trunk light. I couldn’t move on with troubleshooting until the circuit was closed. This car has a few issues and I’m grateful for the vast knowledge of this group.
Plugging in this plug does not close any circuit except the light circuit with the light ON, with the light OFF the circuit is not affected. Plugged in or not plugged in does not affect the interior light circuit at all, I currently have the equivalent light in my coupe unplugged and all the other interior lights work just fine.
Until we figure it out, the top doesn’t work, doors don’t lock/unlock with fob, interior lights don’t come on when doors open, etc.
Do you have a photo of the trunk area, not just the area for luggage.
Last edited by onehundred80; May 13, 2018 at 01:10 PM.
Good one, Dave. Looks like I missed that.
I’ll try to get some photos tomorrow. I think they are both still there but I’m not 100% sure about it. Are they both on the left side of the trunk area?
Lift the carpet on the bottom of the trunk, take a picture of the components on the right side and the left side. Post so that the "experts" have an idea of what the problem might be. Lots of possibilites for top not operating, ----- some simple, some not so much.
The Top control module and pump are on the driver's side in the fender well.
The security system pump and controller are in the passenger side fender well.
Take out ALL trunk trim and you will see what you have.
The security system pump and controller are in the passenger side fender well.
Take out ALL trunk trim and you will see what you have.
Start stripping your trunks, I mean the roadster trunk not your boxers.
Thread
Thread Starter
Forum
Replies
Last Post
zombiehunter
Crossfire SRT6
6
Jul 30, 2011 08:48 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



