The 6 is being a PITA :(
So after all that work replacing the IC pump and washer reservior, the SC still isn't working.
I'm just going to bring the thing down to Jerry (EC) and pay him to figure it out.
I'll ask him to install the oil catch can as that appears to be a PITA as well.
I'm sick as a dog and just paid a $250 speeding ticket so if I sound a little grumpy, there's good cause.
Thank you for allowing me to vent.
I'm just going to bring the thing down to Jerry (EC) and pay him to figure it out.
I'll ask him to install the oil catch can as that appears to be a PITA as well.
I'm sick as a dog and just paid a $250 speeding ticket so if I sound a little grumpy, there's good cause.
Thank you for allowing me to vent.
So after all that work replacing the IC pump and washer reservior, the SC still isn't working.
I'm just going to bring the thing down to Jerry (EC) and pay him to figure it out.
I'll ask him to install the oil catch can as that appears to be a PITA as well.
I'm sick as a dog and just paid a $250 speeding ticket so if I sound a little grumpy, there's good cause.
Thank you for allowing me to vent.
I'm just going to bring the thing down to Jerry (EC) and pay him to figure it out.
I'll ask him to install the oil catch can as that appears to be a PITA as well.
I'm sick as a dog and just paid a $250 speeding ticket so if I sound a little grumpy, there's good cause.
Thank you for allowing me to vent.
This is very similar to the issue I had when I first purchased my SRT. You should check the ambient temp sensor. Mine was faulty. It showed correctly in the cabin, but was sending the ECU that it was -36 outside, which made the computer add fuel to keep operating temp appropriate...well when it is 80+ outside, that leads to the S/C overhearting.
It is like a $10 part or something like that and it simple to replace. I don't have the part number off hand here at work, but I'm sure you can find it...or just call the dealer and see what they want to charge you get you a new one.
I just got back from EC and Jerry verified the SC was turning on by unplugging the clutch (clever).
He gave the car a tune and I like the throttle response now but after driving home, it just doesn't have the hair-raising power that it used to have.
I'm wondering if something could be blocking the air intake or maybe the SC clutch is slipping or something???
The car has 11K miles so it sat in storage a lot.
He gave the car a tune and I like the throttle response now but after driving home, it just doesn't have the hair-raising power that it used to have.
I'm wondering if something could be blocking the air intake or maybe the SC clutch is slipping or something???

The car has 11K miles so it sat in storage a lot.
Brian , did you burp/bleed the supercharger intercooler circuit by pinching the hose, like we discussed, after installing the pump ?
You may have air in the system which needs to be purged ..........
https://www.crossfireforum.org/forum...placement.html
You may have air in the system which needs to be purged ..........
https://www.crossfireforum.org/forum...placement.html
Last edited by magredvet; May 16, 2012 at 03:23 PM. Reason: added link
Unplug your Ambient temp sensor from the driver's side lower louvre. Then go check the cabin, it will read one of two things...either -36 or 136 ( or something like that). That is how I found it. The IAT sensor does control fuel/advance, but one parameter is also knowing what the ambient temperature is.
This is also about keeping the whole engine from being well below operating temperature, which is what would happen if the outside temp really was -36.
Brian , did you burp/bleed the supercharger intercooler circuit by pinching the hose, like we discussed, after installing the pump ?
You may have air in the system which needs to be purged ..........
https://www.crossfireforum.org/forum...placement.html
You may have air in the system which needs to be purged ..........
https://www.crossfireforum.org/forum...placement.html
I'm not sure I should drive this to Dallas until it gets figured out.
It hasn't got a needswings coolant isolator setup has it ? ...............in which case you'd need to let the coolant back into the IC circuit before topping up, and closing the isolation valves again
Unplug your Ambient temp sensor from the driver's side lower louvre. Then go check the cabin, it will read one of two things...either -36 or 136 ( or something like that). That is how I found it. The IAT sensor does control fuel/advance, but one parameter is also knowing what the ambient temperature is.
This is also about keeping the whole engine from being well below operating temperature, which is what would happen if the outside temp really was -36.
This is also about keeping the whole engine from being well below operating temperature, which is what would happen if the outside temp really was -36.
I think it's ironed out.
1 of the problems was the w/s switch was in the w position. Reading up on that it appears the car will start off in 2nd gear and won't downshift as easily.
Not the best scenerio when trying to go fast.
Btw, hat's off to Jerry at Eurocharged. That tune was worth every penny.
1 of the problems was the w/s switch was in the w position. Reading up on that it appears the car will start off in 2nd gear and won't downshift as easily.
Not the best scenerio when trying to go fast.
Btw, hat's off to Jerry at Eurocharged. That tune was worth every penny.
Btw, hat's off to Jerry at Eurocharged. That tune was worth every penny.
[/QUOTE]
Told you.................now it needs a pulley and an intake ...........
Told you.................now it needs a pulley and an intake ...........
you aren't the first one to make that mistake.....I have seen others on here bump the switch...but when you put her back in summer mode....it feels even faster than before...lol
Thread
Thread Starter
Forum
Replies
Last Post
maxcichon
Wheels, Brakes, Tires and Suspension
3
Apr 21, 2021 08:29 AM
Musclefan21
Crossfire Coupe
7
Sep 5, 2012 07:11 PM
GraphiteGhost
Crossfire Coupe
3
Apr 1, 2012 05:27 PM
maxcichon
Troubleshooting & Technical Questions & Modifications
5
Aug 30, 2008 10:59 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



