Protective flim on headlights
Protective flim on headlights
Anyone have experience/knowledge on the use of protective film being used on headlights?
I've been told by one source that the headlights are too hot and by another that it is no problem. I'd like to prevent damage to an expensive part. While I'm typing, I'd like to note how valuable this Forum is to a new owner like myself. Thanks.
'05 Graphite Roadster
I've been told by one source that the headlights are too hot and by another that it is no problem. I'd like to prevent damage to an expensive part. While I'm typing, I'd like to note how valuable this Forum is to a new owner like myself. Thanks.
'05 Graphite Roadster
Re: Protective flim on headlights
Originally Posted by rjreiser
Anyone have experience/knowledge on the use of protective film being used on headlights?
I've been told by one source that the headlights are too hot and by another that it is no problem. I'd like to prevent damage to an expensive part.
I've been told by one source that the headlights are too hot and by another that it is no problem. I'd like to prevent damage to an expensive part.
link... http://xpel.com/products/configurato...516&series=599 (scoll down to bottom of page - $59.95).
Re: Protective flim on headlights
Another source...
3M Headlight Protectors (Precut)
Groit's Garage (800) 345-5789
• P/N: 10232
• $73.98
http://www.griotsgarage.com/search.j...=17&search.y=5
I highly recommend them. There is not enough heat generated by the head/fog lights to be a factor (afterall, the head light lens are themselves made of plastic).
3M Headlight Protectors (Precut)
Groit's Garage (800) 345-5789
• P/N: 10232
• $73.98
http://www.griotsgarage.com/search.j...=17&search.y=5
I highly recommend them. There is not enough heat generated by the head/fog lights to be a factor (afterall, the head light lens are themselves made of plastic).
Thread
Thread Starter
Forum
Replies
Last Post
Franc Rauscher
Troubleshooting & Technical Questions & Modifications
14
05-09-2016 12:04 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)