garage floor liners
Armorclad Epoxy Floor Coating
Garage Floor Coating, resurfacing painting and epoxy coatings - The solution to your garage renovation needs - Franchises also available
Garage Floor Paint | Epoxy Concrete Floor Coating | Basement Floor Paint
A few options. I've done this twice and had great, bulletproof results.
In one word: CLEAN!!! Follow all the manufacturer's directions, but the job will only be as good as the surface underneath. If it's painted-remove every little speck. Grease spots? Degrease and degrease again. Other than that, it's just like painting any other surface, only flat!
I'll be doing this house, but only after I can find a way to get my wifes' junk out of the way.
God, I sure miss my 3 1/2 car garage I had in Wisconsin!
Another option I helped a friend with: Tile. If you shop around, you can find super low prices and get a beautiful floor that will last forever too. Just seal the grout lines 48 hours after you float the grout.
Garage Floor Coating, resurfacing painting and epoxy coatings - The solution to your garage renovation needs - Franchises also available
Garage Floor Paint | Epoxy Concrete Floor Coating | Basement Floor Paint
A few options. I've done this twice and had great, bulletproof results.
In one word: CLEAN!!! Follow all the manufacturer's directions, but the job will only be as good as the surface underneath. If it's painted-remove every little speck. Grease spots? Degrease and degrease again. Other than that, it's just like painting any other surface, only flat!
I'll be doing this house, but only after I can find a way to get my wifes' junk out of the way.
God, I sure miss my 3 1/2 car garage I had in Wisconsin!
Another option I helped a friend with: Tile. If you shop around, you can find super low prices and get a beautiful floor that will last forever too. Just seal the grout lines 48 hours after you float the grout.
Thread
Thread Starter
Forum
Replies
Last Post
rampntlion
Engine, Exhaust, Transmission and Differential
21
Feb 11, 2019 08:18 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




