Drivers seat forward and back switch does not work. Switch clicks once in forward switch position. Vertical and tilt motions work.
This seems to be a switch related problem. If so is the switch accessible without completely removing the seat?

 

The best first step would be to download the manual.

You can locate it in 180’s signature

 

You must remove the seat.

 

Thanks Urban E but where do I find 180's signature?

 

Same link is my signature

 

Link to common problem fixes and documentation

 

No u don't have to remove the seat but it makes it a lot easier,,, if it is your switch i have one it is in good shap no scratches but the front screw hole is broken but still works with a small washer . I want $75 + 20 shipping i am trying to load a picture

 

both coupe and roadster are the same. you can remove those 3 screws and the handles and just swap the switches

 

The switch assembly in the photo looks like a passenger side. Are the switches for both sides interchangeable? As I have indicated the vertical and reclining switches both operate.
If the seat is not removed is removing the side panel with the switches difficult to take out?
Thanks,
Jack

 

sorry about that u r right it is the pass side I have this .driver's side that i removed the sw were working when i took it out send me say 8 to 10 shipping ans i will send it to u . I had switched my seats left to right (gave me a new seat on the drivers side) https://www.crossfireforum.org/forum...ght=swap+seats then i got a new seat pass side from a roadster put it in the dr side of my V8 coupe sent u a pm