Shifting
Re: Shifting
Welcome to the forum !
Transmission :
1. low fluid
2. check the electrical connector for leaks
3. replace the 'conductor plate'
TPMS light - pretty normal these days - the batterys in the tire sensors don't last much past 10 years.
CEL - go to Advance or Autozone and have them read the codes, or buy yourself a cheap code reader.
Post results back here.
Transmission :
1. low fluid
2. check the electrical connector for leaks
3. replace the 'conductor plate'
TPMS light - pretty normal these days - the batterys in the tire sensors don't last much past 10 years.
CEL - go to Advance or Autozone and have them read the codes, or buy yourself a cheap code reader.
Post results back here.
Re: Shifting
posted yesterday 2005 crossfire with automatic trans shifting problems would not shift out of 1st gear , i was advise to get a code reader and post information.. what i found was code po715 input / turbine speed sensor a circuit so could it be a simple replacement of a input turbine speed sensor a circuit.
Re: Shifting
Actually, that is the "conductor plate" that I mentioned.
Youtube search 722.6 conductor plate for several good DIY's.
You will need a new filter, fluid and a connector replacement .
A lift will certainly help, but it can be done on jack stands.
Here's a good complete kit : https://www.fcpeuro.com/products/mer...on-service-kit
Youtube search 722.6 conductor plate for several good DIY's.
You will need a new filter, fluid and a connector replacement .
A lift will certainly help, but it can be done on jack stands.
Here's a good complete kit : https://www.fcpeuro.com/products/mer...on-service-kit
Thread
Thread Starter
Forum
Replies
Last Post
sailorjoe
Troubleshooting & Technical Questions & Modifications
2
02-26-2005 10:18 PM
Rwright2
Troubleshooting & Technical Questions & Modifications
4
11-02-2003 01:31 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)