Well I Have An 04 Crossfire And It Wnt Start! The Car Would Click When I Tried To Start Her. So Figured Hey Its The Starter So I Replaced It. Guess What Still Wont Start.... Doin The Same Thing Get It To Click But No Start! Any Advice

 

Did it ever occur to you to charge the battery?
If you go to start the car and all you get is the rapid relay clicking sound its simply a weak battery.

 

Well About 2 Weeks Ago The Alternator Went Replaced It And The Battery! So Im Confused We Got It To Start With A Good Ole Push Down The Hill And Dump The Clutch...

 

Good battery connections? What is the voltage of the battery? What is the voltage when you attempt to start it? What is the voltage at the battery when the engine is running?
James

 

its electrical, nothing to do with the starter
The battery could just be bad.. bad cell or something. Or the alternator wasnt installed properly.

 

Well I Dnt Think It Is The Batt Or Alternator Cause It Wnt Even Start With Jumper Cables?

 

unhook the leads from the battery and connect the jumper cables to the battery leads and see what happens. Remove your battery from the situation.

batteries can be so dead that they cant be jumped

 

Exactly What I Tried Put Another Batt In Then Tried It Directly To The Leads. Nothin! Will Pushstart Fine Keep Parkin On A Hill Till I Can Figure It Out. But Im Clueless.

 

everything on the starter installed correctly?

 

Ya Its All Right! Had My Mechanic Do It. And Even Hes Stumped... Through Out Maybe A Neutral Position Sensor? But Dnt Know?

 

the neutral position sensor shouldnt matter, you can crank the car with it in any gear as long as the clutch is in.

If the clutch interlock switch on the clutch pedal went bad, it wouldnt even attempt to turn over.

Double check that the connection on the alt are secure. even the slightest loose connection can cause issues.

 

Well Checked All The Conn On Batt Alt Starter All Secure And Correct! When I Attempt To Start Still Clicks Once And I Can Hear The Fuel Pump Turn On But No Engine Turn!!!

 

I Have No Idea Whats Wrong With A Push Start It Drives Fine Doesnt Die Or Cut Out No Over Heating Warning Light Nothing Just Wnt Start!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

No Crank - Relay Control Module

Crank no Fire - Crank Position Sensor

 

John, you sound like DJ....

 

If It Were Either The Crank Sensor Or Relay Wouldnt Tthe Car Have Issues Running? She Drives Fine And Can Leave Her On For Hours, Just Wont Start

 

No.... once started it would run fine.... though I think some may have reported random dieing....

Check your RCM solder joints first..... based on your description it dosent sound like the CPS...

 

Hahah I actually quoted him directly...

 

This is not the CPS, sounds like it MIGHT be solder joint fractures on the Relay Control Module circuit board.

Pull the RCM as described in "How to relay control fix" and take a look at it. THEN, get back to us!

 

Well Disassembled The Rcm And The Solder Looks Fine But Im No Electrician. The Only Thing I Notice Is The Barbs Do Extend Past The Solder.