Troubleshooting & Technical Questions & Modifications Have technical or modification questions about the Crossfire? Find out the answer, or give advice in here!

Key Fab doesn't open or close locks

Thread Tools
 
Old Jun 23, 2019 | 06:00 PM
  #1 (permalink)  
starduster's Avatar
Thread Starter
Joined: Jul 2011
Posts: 1
Likes: 0
From: Omaha Nebraska
Default Key Fab doesn't open or close locks

Fuse # 9 blows. can't locate the short. Courtesy light, trunk light doesn't work. Key will open drivers door, but passengers door
will only open from inside handle. Switch on dash will open and close locks and trunk, but only inside the car when doors are closed.
Anything to do with the Body Control Module and if so where is it located? Thanks.
 
Reply
Old Jun 23, 2019 | 06:55 PM
  #2 (permalink)  
ala_xfire's Avatar
Senior Member
Joined: Dec 2010
Posts: 12,780
Likes: 184
From: Lineville, AL
Default Re: Key Fab doesn't open or close locks

Most likely you have gotten water into the locking pump module, located under the passenger side trunk flooring.
You gotta remove a heap of trim to get to it,
but you can go underneath the car and locate one of the rubber plug things and poke a hole in it to see if water is present.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
zombiehunter
Crossfire SRT6
2
Mar 16, 2014 03:55 PM
kbputt
Crossfire Roadster
14
Nov 11, 2010 12:38 PM
TVT_DESIGN
Troubleshooting & Technical Questions & Modifications
5
Jun 4, 2009 03:44 PM
CECrossfire
Crossfire Coupe
3
Jan 13, 2009 09:30 PM
waldig
Crossfire SRT6
1
Dec 16, 2008 01:09 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -4. The time now is 07:34 AM.