Crossfire 04 ,automatic door locks
When park I unlock the car everything is OK, then when when start driving only the passenger side lock automatically after you reach certain speed, not the driver door. But with the remote both doors work OK.
Also if I don't drive the car in 2 weeks the battery will be depleted,I have to use jumper cables after that no problems until 2 weeks later.
Any advise will be apprecited.
Also if I don't drive the car in 2 weeks the battery will be depleted,I have to use jumper cables after that no problems until 2 weeks later.
Any advise will be apprecited.
The battery drain is most likely the siren under the cowl in front of the windshield. Use the search feature and you will get lots of insight.
When park I unlock the car everything is OK, then when when start driving only the passenger side lock automatically after you reach certain speed, not the driver door. But with the remote both doors work OK.
Also if I don't drive the car in 2 weeks the battery will be depleted,I have to use jumper cables after that no problems until 2 weeks later.
Any advise will be apprecited.
Also if I don't drive the car in 2 weeks the battery will be depleted,I have to use jumper cables after that no problems until 2 weeks later.
Any advise will be apprecited.
Use jumper cables as explained in the Owners Hand book or you could have major expenses.
Hello the battery drain is most likely the siren great tutorial on here on how to remove it.
the locking issue is may be water in your trunk there is another great thread on here to check it then how to move forward. Start by sliding a piece of paper down beside the foam inserts in your trunk on the passenger side if it comes up wet then you know.
hope this helped
the locking issue is may be water in your trunk there is another great thread on here to check it then how to move forward. Start by sliding a piece of paper down beside the foam inserts in your trunk on the passenger side if it comes up wet then you know.
hope this helped
Thread
Thread Starter
Forum
Replies
Last Post
polmstead
Troubleshooting & Technical Questions & Modifications
8
May 9, 2005 07:06 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



