TSBs and How-To Articles This is for information on Technical Service Bulletins and for posting How-To Articles.

no start after t/s battery drain by removing fuses

Thread Tools
 
Old Jul 22, 2022 | 05:45 PM
  #1 (permalink)  
white05conv's Avatar
Thread Starter
Joined: May 2009
Posts: 25
Likes: 1
Angry no start after t/s battery drain by removing fuses

I was trying to isolate which system is draining my battery by removing each fuse 1 at a time and watching amp draw
after checking fuses car wont start cranks but no start. is there something I have to reset
 
Reply
Old Jul 22, 2022 | 05:57 PM
  #2 (permalink)  
ZERACER's Avatar
Senior Member
Joined: Nov 2006
Posts: 6,631
Likes: 776
From: Orange County CA.
Default Re: no start after t/s battery drain by removing fuses

Are you sure you got all of the fuses back properly? Also, hopefully you didn't cause an electrical spike. Usually, the battery draining is caused by the old internal batteries in the alarm siren leaking and shorting out.
 
Reply
Old Jul 22, 2022 | 07:12 PM
  #3 (permalink)  
white05conv's Avatar
Thread Starter
Joined: May 2009
Posts: 25
Likes: 1
Default Re: no start after t/s battery drain by removing fuses

I will recheck all of the fuse and then check the screem
 
Reply
Old Jul 23, 2022 | 09:52 AM
  #4 (permalink)  
ZERACER's Avatar
Senior Member
Joined: Nov 2006
Posts: 6,631
Likes: 776
From: Orange County CA.
Default Re: no start after t/s battery drain by removing fuses

If you disconnect the battery, reconnect it and get two almost starts and then nothing, it is probably the screem. Josh Chase at MSS checks and repairs them.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
CaptainTommy
Troubleshooting & Technical Questions & Modifications
11
Oct 11, 2025 12:31 AM
paulius
Crossfire SRT6
11
Sep 26, 2019 09:53 PM
shyloe
Troubleshooting & Technical Questions & Modifications
68
Dec 9, 2017 11:54 AM
KROSSFIRE1988
Troubleshooting & Technical Questions & Modifications
38
May 4, 2010 04:54 PM
mcd0minguez
Audio, Video and Electronics
10
Nov 22, 2009 08:56 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -4. The time now is 11:09 AM.