Crossfire SRT6 A place to discuss SRT-6 specific topics.

Belt Slippage or Boost Leak

Thread Tools
 
  #1 (permalink)  
Old 06-24-2016, 05:14 PM
blackpepper's Avatar
Forum Regular
Thread Starter
Join Date: Jan 2011
Posts: 562
Received 9 Likes on 9 Posts
Default Belt Slippage or Boost Leak

My car is running a little slower than normal I lost around 5 mph in the 1/8 an the 1/4 ,I think my belt is slipping causing doing a burnout I don't get that belt squeal anymore after I stop ,and the manifold gaskets haven't been changed in four years,I think that is a place to start oh boost gauge indicates 19 psi with a code three pulley so I know that's code use to indicate 17.5
 
  #2 (permalink)  
Old 06-24-2016, 07:55 PM
amx1397's Avatar
Senior Member
Join Date: Apr 2008
Location: Indialantic Fl.
Posts: 6,362
Likes: 0
Received 202 Likes on 153 Posts
Default Re: Belt Slippage or Boost Leak

Originally Posted by blackpepper
My car is running a little slower than normal I lost around 5 mph in the 1/8 an the 1/4 ,I think my belt is slipping causing doing a burnout I don't get that belt squeal anymore after I stop ,and the manifold gaskets haven't been changed in four years,I think that is a place to start oh boost gauge indicates 19 psi with a code three pulley so I know that's code use to indicate 17.5
I don't get that belt squeal anymore after I stop do u get the belt squeal during the run?

have you done the throttle reset?
when you last ran was the temp as hot as it is this month?
19 lbs of boost sounds like what the code 3 can put out.
try to add about 2 gal of 100 octane gas to just under 1/4 tank.
mph can also be lost by tire spin at the line. did the et drop?
 
  #3 (permalink)  
Old 06-24-2016, 11:08 PM
chuK_138's Avatar
Senior Member
Join Date: Jun 2011
Location: Winter Park, FL
Posts: 1,324
Likes: 0
Received 3 Likes on 2 Posts
Default Re: Belt Slippage or Boost Leak

If there's black dust all over the SC pulley, then you're having slipping issues. 17psi is about right for a 65mm pulley depending on supporting mods. I have a dedicated boost sensor with my Zeitronix setup. Using the datalogger through Eurotune V2 (Eurocharged program) will show a much different reading because it uses a MAP formula to convert to PSI. Not too accurate. I see a true 18 PSI through the Zt-2, maybe 20 PSI through Eurotune. Also, leaking gaskets would show lower boost, not the other way around.
 
  #4 (permalink)  
Old 06-26-2016, 08:12 PM
blackpepper's Avatar
Forum Regular
Thread Starter
Join Date: Jan 2011
Posts: 562
Received 9 Likes on 9 Posts
Default Re: Belt Slippage or Boost Leak

I have the modded stock manis,dcai,large air filters,sl55 fuel pump,replace the belt car pull better,car has cork gaskets from prior owner 4 fours ago probably time to change them still going with oem gaskets an that night at the track it was 96 degrees an humid
 
  #5 (permalink)  
Old 06-26-2016, 08:14 PM
blackpepper's Avatar
Forum Regular
Thread Starter
Join Date: Jan 2011
Posts: 562
Received 9 Likes on 9 Posts
Default Re: Belt Slippage or Boost Leak

car has been 7.89@90 on street tires but i can only muster that time on a lighter wheel an drag radials,an 8.20@87 on street tires now
 
  #6 (permalink)  
Old 06-26-2016, 08:15 PM
blackpepper's Avatar
Forum Regular
Thread Starter
Join Date: Jan 2011
Posts: 562
Received 9 Likes on 9 Posts
Default Re: Belt Slippage or Boost Leak

on nitrous it a 11.3@122 all day but if i get what i lost i should be a 10 second car,
 
  #7 (permalink)  
Old 06-26-2016, 08:18 PM
blackpepper's Avatar
Forum Regular
Thread Starter
Join Date: Jan 2011
Posts: 562
Received 9 Likes on 9 Posts
Default Re: Belt Slippage or Boost Leak

no belt squeal during the run just doing a burnout an the sudden stop cause the belt to squeal
 
  #8 (permalink)  
Old 06-27-2016, 10:25 PM
Join Date: Oct 2007
Location: Great Falls, Montana ( Big Sky Country)
Age: 67
Posts: 1,271
Likes: 0
Received 0 Likes on 0 Posts
Default Re: Belt Slippage or Boost Leak

I have NEVER had belt squeal...
I use the Goodyear "Gator Back" belt, I think it is without a doubt the best SC belt available.
 
  #9 (permalink)  
Old 06-30-2016, 05:51 PM
blackpepper's Avatar
Forum Regular
Thread Starter
Join Date: Jan 2011
Posts: 562
Received 9 Likes on 9 Posts
Default Re: Belt Slippage or Boost Leak

The squeal is the sudden deceleration of the supercharger an belt after the burnout is over,i heard the same noise on two e55s also.
 
  #10 (permalink)  
Old 06-30-2016, 07:25 PM
amx1397's Avatar
Senior Member
Join Date: Apr 2008
Location: Indialantic Fl.
Posts: 6,362
Likes: 0
Received 202 Likes on 153 Posts
Default Re: Belt Slippage or Boost Leak

are you sure it is not the (blow off valve) listen to this one of my car from 2 years ago.

 
  #11 (permalink)  
Old 06-30-2016, 09:27 PM
dinasrt's Avatar
Senior Member
Join Date: Apr 2010
Location: Mendocino, CA
Age: 67
Posts: 2,404
Received 7 Likes on 7 Posts
Default Re: Belt Slippage or Boost Leak

Originally Posted by amx1397
are you sure it is not the (blow off valve) listen to this one of my car from 2 years ago.

amx1397 @10.79 fastest crossfire in the world. - YouTube
Blow off valve?
 
  #12 (permalink)  
Old 06-30-2016, 10:08 PM
amx1397's Avatar
Senior Member
Join Date: Apr 2008
Location: Indialantic Fl.
Posts: 6,362
Likes: 0
Received 202 Likes on 153 Posts
Default Re: Belt Slippage or Boost Leak

it proper name is supercharger bypass valve,,,,but it is a blow off valve..

read this https://www.google.com/url?sa=t&rct=...XAeWnGdIL7LwLQ
 
  #13 (permalink)  
Old 07-07-2016, 02:42 PM
Join Date: Oct 2015
Location: Canada
Age: 51
Posts: 128
Likes: 0
Received 0 Likes on 0 Posts
Default Re: Belt Slippage or Boost Leak

Originally Posted by amx1397
it proper name is supercharger bypass valve,,,,but it is a blow off valve..

read this https://www.google.com/url?sa=t&rct=...XAeWnGdIL7LwLQ
Interesting readings, u have pics of ur engine bay?
Or mod list would like to know more thanks
 
  #14 (permalink)  
Old 07-07-2016, 03:59 PM
amx1397's Avatar
Senior Member
Join Date: Apr 2008
Location: Indialantic Fl.
Posts: 6,362
Likes: 0
Received 202 Likes on 153 Posts
Default Re: Belt Slippage or Boost Leak

Originally Posted by Morphh
Interesting readings, u have pics of ur engine bay?
Or mod list would like to know more thanks
everything is to your left,
 
  #15 (permalink)  
Old 07-07-2016, 08:28 PM
blackpepper's Avatar
Forum Regular
Thread Starter
Join Date: Jan 2011
Posts: 562
Received 9 Likes on 9 Posts
Default Re: Belt Slippage or Boost Leak

Interesting where is this valve located
 
  #16 (permalink)  
Old 07-07-2016, 08:30 PM
blackpepper's Avatar
Forum Regular
Thread Starter
Join Date: Jan 2011
Posts: 562
Received 9 Likes on 9 Posts
Default Re: Belt Slippage or Boost Leak

Thats the sound lol woow
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Bayukbros
Crossfire Roadster
2
05-06-2016 10:52 AM
KrisFire
All Crossfires
41
04-29-2016 03:09 PM
jthaub
Troubleshooting & Technical Questions & Modifications
1
04-19-2016 06:47 PM
Buchacho
Troubleshooting & Technical Questions & Modifications
0
04-12-2016 10:01 AM
mobilefitt
Engine, Exhaust, Transmission and Differential
20
04-10-2016 08:02 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 


Quick Reply: Belt Slippage or Boost Leak



All times are GMT -4. The time now is 09:47 PM.