Just contacted local Chrysler Dealer, gave me a quote for 109.00 dollars for this tool. Any suggestions where I can find one more reasonable? (local MB dealer not helpful)

 

Here are some comments that were posted a while back....
<https://www.crossfireforum.org/forum/crossfire-roadster/39718-multifunction-tool.html>.....it seems as though E-bay is the way to go.

Good luck.

 

You have come to the right place!

There are plenty of us multifunction tools here.

 

And 32Krazy! is the ring leader.

 

If you can cut and file one from metal, here's the sizes, it's .135 thick, 1/8" is close enough.

Here are the two variations I have had, I gave the second one away.

If you are really lucky, you may find yours in the pocket on the bulkhead between the seats, others have and it had been there since the car was new.

 

Great Stuff, will start forging one (at work ) tomorrow, should the sharp end be 40" or 4 mm
I assume a piece of 1/4 plate- 12 inch by 3 inch can be used to shape the multi tool
Dave

 

Well the ink ran a bit and the .40" dim'n. looks like 40". The post says 1/8", I forgot it on the drawing, getting old.
One post on here has these made for $50 Canadian.
Heck $50 gets my original.

 

50 for the sketch or the tool ?
1st dibs on the tool,

 

I just had a local make me one. Cost me $40.

 

Does anyone know the part number for the multifunction tool. Just bought a 2005 Limited Convertible and cannot find the tool in the car.

 

Send a PM to Mrmiata, he has some that he had made up for the forum members.

also, have a look at the video that pizzaguy did :
https://www.crossfireforum.org/forum...operation.html

 

Send me a check for $20.00 I'll mail you my extra.



Down to only one XF now.

 

go to mrmiata!!!!!!!!
he did a GREAT job on mine and others.

 

Does anyone know for sure that the tool for the convertible is identical to the tool that came with the coupe?

 

My 04 coupe..came with wrench.. Wife's 05 roadster .. came with wrench.. identical.

 

These are the shapes of the tools that came with the Crossfire, at least the two that I have had.

Top is Chrysler part #5140795AA or Mercedes part #A 193 899 02 80

Bottom is Chrysler part #5127223AA or Mercedes part #A 193 899 03 80



Also attached is the drawing of the CLK tool, it has the 6mm Allen key attached to it. As put on the forum by Top Hydraulics.

 

Thanks.......mailing my extra to Angelomd above.....he's got a roadster....should work OK.

 

My new to me roadster did not come with one. I confirmed each 10mm boxend wrench that I have worked OK for opening the decklid and lifting the top. It did not have to be especially thin to work though the slot makes it look like it does. I had a longer and thinner than average SnapOn 10mm that does work better so I will store that in the cab along with a right-sized screwdriver. Thanks for the YouTube video. I used that and could not find a position that required a special offset for the wrench. Every position worked fine.

 

This makes even more sense:
A single tool that combines the 10 MM for the tonneau, and the 6 mm hex for the bow lock -
Search SiteSearch Key - 2088990080 - KEY - ES#1746403