Dyno'd the 6, 326 & 344 @5000 RPM
Thread Starter
|
Senior Member
Joined: Jul 2007
Posts: 2,134
Likes: 2
From: Williamsburg, Va
Dyno'd the 6, 326 & 344 @5000 RPM
I forgot to post this the other day...
I went to a local Dyno Day on Saturday to see if I could get a number. I know these things are hard to dyno, but we were able to get accurate A/F and Ignition readings. Of course it fell off at 5000RPM and all the dash lights came on as promised...
Long story short, in fourth gear it put down 326 HP and 344 ft. lbs. I thought that was pretty decent for just a Code 3 Pulley, single NW intake, Johnson Pump, InMotion Tune and Resonator Delete.
This was on an AWD DynoJet.
I went to a local Dyno Day on Saturday to see if I could get a number. I know these things are hard to dyno, but we were able to get accurate A/F and Ignition readings. Of course it fell off at 5000RPM and all the dash lights came on as promised...
Long story short, in fourth gear it put down 326 HP and 344 ft. lbs. I thought that was pretty decent for just a Code 3 Pulley, single NW intake, Johnson Pump, InMotion Tune and Resonator Delete.
This was on an AWD DynoJet.
Senior Member
Joined: Aug 2009
Posts: 3,459
Likes: 12
From: Warner Robins, GA
Re: Dyno'd the 6, 326 & 344 @5000 RPM
That sounds about right. I have the same mods as you, with the exception that I have an LET tune instead of InMotion. Mine was dyno'd on a DynoJet as well, and my numbers are 337.3 HP and 344 FT LBS Torque. Congrats on the good numbers.
Thread
Thread Starter
Forum
Replies
Last Post
johnnycross413
Troubleshooting & Technical Questions & Modifications
1
Mar 4, 2016 04:49 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
