how to pull out the headlight?
I was trying to replace the headlight and droped the clip in the headlight. I cant get to it without pulling the headlight out. Is there a third bold on the bottom of the light? If so how do i get to it.
Originally Posted by mikep330
I was trying to replace the headlight and droped the clip in the headlight. I cant get to it without pulling the headlight out. Is there a third bold on the bottom of the light? If so how do i get to it.

There is an access panel in the front wheel wells, on each side of the car, turn the wheels one way or the other for better access.
I believe there are two more screws on each headlight assembly
Hi Mikep330
I have just swapped out both my headlamps , follow the link https://www.crossfireforum.org/forum...ment-srt6.html This how i did should take about 1/2 hour .
Cheers
Andy
I have just swapped out both my headlamps , follow the link https://www.crossfireforum.org/forum...ment-srt6.html This how i did should take about 1/2 hour .
Cheers
Andy
Last edited by ZeroZero; Jun 24, 2009 at 10:22 AM.
Originally Posted by ZeroZero
Hi Mikep330
I have just swapped out both my headlamps , follow the link https://www.crossfireforum.org/forum...ment-srt6.html This how i did should take about 1/2 hour .
Cheers
Andy
I have just swapped out both my headlamps , follow the link https://www.crossfireforum.org/forum...ment-srt6.html This how i did should take about 1/2 hour .
Cheers
Andy
Hi Mikep330
I made them up myself , There is a thread within the UK section on how i went about it
, They have work out ok but still not sure about the RED inside the headlamp unit i think its making the light rings look abit purple , But all good for now ,
Link https://www.crossfireforum.org/forum...d-fitting.html
Cheers
Andy
I made them up myself , There is a thread within the UK section on how i went about it
, They have work out ok but still not sure about the RED inside the headlamp unit i think its making the light rings look abit purple , But all good for now ,Link https://www.crossfireforum.org/forum...d-fitting.html
Cheers
Andy
Thread
Thread Starter
Forum
Replies
Last Post
Franc Rauscher
Troubleshooting & Technical Questions & Modifications
14
May 9, 2016 12:04 PM
tritongreen
Troubleshooting & Technical Questions & Modifications
0
Sep 18, 2015 07:32 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




