Door Handle Installation
Re: Door Handle Installation
Did you drop the allen head screw into the door (the one that you removed by pulling back the weather strip)?
Take your time. Set the black gasket in place (it has two small hooks to hold on to the door) then slide the pull handle in and slide it forward into the catch on the door.
Then use your finger or a screwdriver to hook the flat metal latch (in the door) onto back of the handle. Eaiser if you have the door panel off, but can be done with it on. Once this is done it will stay in place (if you dont slide it back).
Fit the keyset into the door (you'll see where it goes) then screw the allen head bolt into it from behind the weather strip (long allen wrench needed).
Don't ask me how I know... Good Luck...
Take your time. Set the black gasket in place (it has two small hooks to hold on to the door) then slide the pull handle in and slide it forward into the catch on the door.
Then use your finger or a screwdriver to hook the flat metal latch (in the door) onto back of the handle. Eaiser if you have the door panel off, but can be done with it on. Once this is done it will stay in place (if you dont slide it back).
Fit the keyset into the door (you'll see where it goes) then screw the allen head bolt into it from behind the weather strip (long allen wrench needed).
Don't ask me how I know... Good Luck...
Thread Starter
|
Forum Regular
Joined: May 2009
Posts: 606
Likes: 1
From: North Jersey
Re: Door Handle Installation
thank you very much!! i will try this around noon wen i get out of work. how will i latch on handle by my hand with out taking the panel off? is it self explanatory?
Thread
Thread Starter
Forum
Replies
Last Post
Sweet2002
Crossfire SRT6
6
Jul 24, 2015 07:57 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
