ESP pressure sensor 1
ESP pressure sensor 1
Hi all
Have the dreaded esp/bas light on, intermittently, have had the codes read with the result C1141 pressure sensor current - 008 + zero point and offset of stored component B34/1 (ESP pressure sensor 1)
anybody out there any idea? have renewed brake pedal switch. Car runs ok when light is on, seems less likely to illuminate when started with foot on the brake pedal.
would help if I knew where esp pressure switch 1 is located
never posted before hope this is correct etiquette
Thanks
Have the dreaded esp/bas light on, intermittently, have had the codes read with the result C1141 pressure sensor current - 008 + zero point and offset of stored component B34/1 (ESP pressure sensor 1)
anybody out there any idea? have renewed brake pedal switch. Car runs ok when light is on, seems less likely to illuminate when started with foot on the brake pedal.
would help if I knew where esp pressure switch 1 is located
never posted before hope this is correct etiquette
Thanks
Re: ESP pressure sensor 1
Hi all
Have the dreaded esp/bas light on, intermittently, have had the codes read with the result C1141 pressure sensor current - 008 + zero point and offset of stored component B34/1 (ESP pressure sensor 1)
anybody out there any idea? have renewed brake pedal switch. Car runs ok when light is on, seems less likely to illuminate when started with foot on the brake pedal.
would help if I knew where esp pressure switch 1 is located
never posted before hope this is correct etiquette
Thanks
Have the dreaded esp/bas light on, intermittently, have had the codes read with the result C1141 pressure sensor current - 008 + zero point and offset of stored component B34/1 (ESP pressure sensor 1)
anybody out there any idea? have renewed brake pedal switch. Car runs ok when light is on, seems less likely to illuminate when started with foot on the brake pedal.
would help if I knew where esp pressure switch 1 is located
never posted before hope this is correct etiquette
Thanks
There are two pressure sensors on the master cylinder. Look at them.
Look at the Service Manual (click). Down load it for future reference.
Last edited by onehundred80; 05-10-2014 at 12:40 PM.
Re: ESP pressure sensor 1
Thanks for the info.
printed off relevant pages of workshop manual found out esp pressure switch 1 is mounted on the master cylinder. cleaned connections etc, still the same. purchased second hand slk master cylinder with sensors, replaced sensor, bled brakes- no esp light so far! cost £25 and some brake fluid.
Thanks for your help
printed off relevant pages of workshop manual found out esp pressure switch 1 is mounted on the master cylinder. cleaned connections etc, still the same. purchased second hand slk master cylinder with sensors, replaced sensor, bled brakes- no esp light so far! cost £25 and some brake fluid.
Thanks for your help
Thread
Thread Starter
Forum
Replies
Last Post
rampntlion
Engine, Exhaust, Transmission and Differential
21
02-11-2019 08:18 AM
bobbie
WTB - Items/Parts Wanted to Buy - Archive
5
09-12-2015 12:49 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)