Crossfire Wont Sart
Re: Crossfire Wont Sart
"yes i did.....no start after or engine crank after having the battery cables touch...."
It didn't go through any cycles of starting and stalling when reconnected.
He also replaced the battery with a new one at some point and had no crank at all.
His Crossfire degraded from initially just throwing a code to cranking with a quick stall (only twice) to not cranking at all even after disconnecting the battery. I don't see any indications of a SKREEM malufunction. That's a good thing.
Would you agree that it makes the most sense for him to first eliminate the possibility of the #1 cause of all the symptoms he has experienced? The RCM.
Re: Crossfire Wont Sart
Seems "most" the times the RCM acts up is when it heats up from the car running.. but you can't rule it out. Member of the face book page.. discovered rodents had made a meal of wiring after replacing the battery for "no start".. so those are the two areas I would be looking into.
Re: Crossfire Wont Sart
I don't see a report of both FOB being used to try and start the car...
Yup, that leaves the RCM as the most common issue. If this were my car I would put a Bosch CPS on order for the glove box.
Thread
Thread Starter
Forum
Replies
Last Post
xfireon20z
Cars For Sale - Archive
8
03-15-2016 04:28 PM
rtaylo
Troubleshooting & Technical Questions & Modifications
1
11-14-2015 11:39 AM
MRGR3YXF
Cars For Sale - Archive
5
11-12-2015 03:38 PM
stevangar
Cars For Sale - Archive
7
11-12-2015 08:43 AM
thatcham
Cars For Sale - Archive
3
10-05-2015 02:41 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)